radios.net.au shop - Yaesu FT-950 HF VHF Radio FT950

The Yaesu FT-950 is an all mode HF/6m transceiver with built-in multifunction 32-bit floating point digital signal processor (which offers adjustable IF width, IF shift, notch filter and countour features). The radio has a multicolor LCD display, and features a built-in high-speed automatic antenna tuner, built-in RS-232C port for computer control, built-in CW contest keyer, built-in high stability crystal oscillator, triple-conversion receiver design, bar graph S/PO meter, 99 memory channels, multiple scanning modes, and more. Yaesu’s Rotator Control function even allows direction and speed control their popular G-800DXA, G-1000DXA and G-2800DXA rotators-right from the front panel of the rig! The radio is supplied with a hand microphone with up/down frequency controls and a fused DC power cord.

FT-950 TECHNICAL SPECIFICATIONS
RX coverage    30 kHz - 60 MHz
sensitivity    .2 µv, typical
selectivity    15, 6, 2.4 kHz, 500 Hz
frequency stability    1 PPM
power output    100 Watts

input voltage    13.8 vDC, ±10%
dimensions    4.5" H x 14.4" W x 12.4" D
weight    22 pounds

FT-950 Specifications

GENERAL
RX Frequency Range:	30 kHz to 56 MHz
TX Frequency Ranges:	160 to 6 m (Amateur bands only)
Frequency Stability:	±0.5 ppm (after 1 min. @ 25 °C)
Operating Temperature Range:	14 ° - 122° F (-10 °C ~ +50 °C)
Emission Modes:	LSB, USB, CW, F3E FM, F1B RTTY, F1D Packet, F2D Packet
Frequency Steps:	1/10 Hz for SSB/CW/AM
0	100 Hz for FM
Antenna Impedance:	50 ohms balanced, 16.7 to 150 Ohms, unbalanced (Tuner ON, TX only)

Power Consumption:	13 VDC
RX (no signal)	2.0A
RX (signal)	2.5A
TX (100 W)	22 A

Supply Voltage:	13.8 VDC
Dimensions (WHD):	14.4 x 4.5 x 12.4 inches
Weight (approx.):	28.7 lbs.
0
TRANSMITTER
Power Output:	Adjustable 5 to 100 watts (2-25 watts AM carrier),
0	50% @ 100 watts (FM & RTTY, 3-minute TX)
Modulation Types:	J3E (SSB) Balanced,
	A3E (AM) Low-level (early stage),
	F3E (FM) Variable reactance,
Maximum FM Deviation:	±5.0 / ±2.5 kHz
Harmonic Radiation:	Better than -60 dB (Typical)
SSB Carrier Suppression:	At least 60 dB below peak output
Undesired Sideband Suppression:	At least 60 dB below peak output
Audio Response (SSB):	Not more than -6 dB from 300 to 2700 Hz
3rd-order IMD:	- 31 dB 14 MHz @ 100 watts PEP
Microphone Impedance:	600 Ohms (200 to 10k ohms)
0
RECEIVER
Circuit Type:	Triple-conversion superheterodyne (VFO-A)
Intermediate Frequencies:	0
VFO A:	69.450 MHz/450 kHz/30 kHz [24kHz for AM/FM]

Sensitivity:
Modes	0.5 - 1.8 MHz	1.8 - 30 MHz	50 - 54 MHz
SSB (2.4 kHz)	2 uV	0.2 uV	0.125 uV
AM (6 kHz)	6 uV	2 uV	1 uV
FM	-	0.5 uV (28-30 MHz)	.35 uV
(with RF2 amp on)

Selectivity (-6/-60 dB):
Modes	Min. -6 dB BW	Max. -60 dB
SSB	2.4 kHz	3.6 kHz
AM	6 kHz	15 kHz
CW/RTTY/Packet	500 Hz	750 Hz
FM	15 kHz	25 kHz

IF Rejection (1.8 ~ 30 MHz):
Image Rejection (1.8 ~ 30 MHz):	70 dB or better (160-10m)
Maximum Audio Output:	2.5 W into 4 Ohms with <10 % THD
Audio Output Impedance:	4 to 8 Ohms
Specifications are subject to change, in the interest of technical improvement, without notice or obligation.