radios.net.au shop - Icom 92AD VHF UHF Hand Held Radio IC-92AD

The Icom IC-92AD is a rugged 5 watt dualband HT with D-STAR built-in! Three RF power levels are available. It is built military tough. The IC-92AD (and optional HM-175GPS) have superior waterproof protection and is equivalent to IPX7 (1 meter underwater for 30 minutes). The aluminum diecast chassis and gasketsealed housing provide performance you can count on in harsh outdoor environments. Icom’s original wideband PA circuit and supplied lithium-ion battery pack provides 5 watts (typical) output power on both VHF and UHF bands. The supplied BP-256 provides up to 6/5.5 hours of operating time (Stand-by duty ratio= 1:1:8). When you do not need full power operation, you can reduce output power to 2.5/0.5/0.1 watts to conserve battery consumption. The 92AD features a multi-line, full dot-matrix display with simple bandscope. With this backlit display you cand see the alphanumeric channel name, bandscope, received message and position information, etc. You can even change the display setting to show frequency or memory name in the center of the display. The four cursor direction buttons on the keypad give you quick and intuitive access to many settings. The dual volume/channel knob provides convenient channel selection and volume control. And of course you have keypad entry. The built-in voice recorder (in DV mode only) records an incoming call for up to 30-seconds (or 15 sec. × 2 tracks, 10 sec. × 3 tracks). For automated outgoing calls, you can pre-record up to 10 seconds of your callsign and/or CQ message in the IC-92AD’s voice memory.

The VFO-A receive range is 0.495-823.990, 849-868.990 and 894-999.990 MHz. The VFO-B receive range is 118-174 and 350-470 MHz. You get dualwatch receiver capability, allowing you to receive on two bands simultaneously (including the same band). By pushing and holding the [Main/Dual] button, you can easily turn dualwatch on and off, while a single press toggles the active VFO channels (A band/B band) (some frequency restrictions apply).

The IC-92AD comes with BP-256 Lithium Ion Battery, MB-111 belt clip, flexible SMA antenna, wrist strap and BC-167A wall charger.

To make your purchase simply peruse the list of available options for this radio below. Click in the tick box alongside the option if you wish to add it to your order.

Then click on the "Add to Basket" button at the foot of the page and this item plus any of any options you have selected will be added automatically to your shopping cart.

You may now proceed to check-out / payment or you can continue shopping for further items to add to your order. If you are looking for a specific item remember to use the search box at top right of every page on this website.

IC-92AD Specifications

General

Frequency coverage:

2 Meter Transmit	70 cm Transmit	Receive
144-148 MHz	420-450 MHz *2	0.495-999.990 MHz *1

*1 Except 824-849, 869-894 MHz cell band; *2 Guaranteed 440-450 MHz only;

Mode: FM, WFM (Rx only), AM (Rx only)
Number of memory channels: 1304 (including 100 program scan edge, 5 call)
Frequency stability: ± 2.5 ppm -4°F to +140°F (-20°C to +60°C;)
Useable temperature range: +14°F to +140°F (-10°C to +60°C)
Power supply : 10 to 16 VDC or BP-256 7.4 VDC specified battery pack
Current drain (at 7.4 V DC):
- Tx High VHF/UHF: 1.8/2.1A typical
- Tx Mid VHF/UHF: 1.2/1.5A typical
- Tx Low VHF/UHF: 0.6/0.7 typical
- Tx Super Low VHF/UHF: 0.4/0.4 typical
- Rx rated audio: 200 mA typical
- Stand By: 100 mA typical
Tuning steps: 5, 6.25, 8.33 (Air band), 9 (MW), 10, 12.5, 15, 20, 25, 30, 50, 100 and 200 kHz
Antenna connector: SMA (50 ohm)
Dimensions (projections not included):
- 2 9/32 (W) x 4.5 (H) x 1.4 (D) inches
- 59(W) x 112(H) x 35(D) mm
Weight (approximate, with antenna and BP-217):
- 11.5 oz (325 g.)

Transmitter

Output power (at 8 V DC):
- High: 5.0 W
- Medium: 2.5 W
- Low: 0.5 W
- Super Low: 0.1 W
Modulation system: variable reactance frequency modulation
Max. frequency deviation: ±5.0/±2.50 kHz FM Wide/Narrow
Spurious emissions: Less than -60 dB
External microphone connector: 3-conductor, 2.5 (d) mm (1/8") 2000 ohm

Receiver

Receive system: Double conversion superheterodyne
Intermediate frequencies:
- 1st: 61.65 MHz FM/AM 59.25 MHz WFM
- 2nd: 450 kHz (except WFM which is 13.35MHz)
- 3rd: 1.95 MHz [WFM]
Sensitivity (except spurious points):
- FM (at 12 dB SINAD 3.5 kHz dev.)
  - 1.625-29.995 MHz: 0.4 µV
  - 30-75.995 MHz: 0.25 µV
  - 76-117.995 MHz: 0.25 µV
  - 118-173.995 MHz: 0.14 µV
  - 144-148 MHz: 0.16 µV
  - 174.005-259.995: 0.32 µV
  - 260-349.995 MHz: 0.32 µV
  - 350-469.995 MHz: 0.16 µV
  - 470.005-599.995 MHz: 0.32 µV
  - 600-999.995: 0.56 µV
- WFM (at 12 dB SINAD 52.5 kHz dev.)
  - 476-108 MHz: 1 µV
  - 175-221.995 MHz: 1.8 µV
  - 470-770 MHz: 2.5 µV
- AM (at 10 dB S/N)
  - 0.495-4.995 MHz: 1.3 µV
  - 5-29.995 MHz: 0.56 µV
  - 118-136 MHz: 0.5 µV
  - 222-246.995 MHz: 0.79 µV
  - 247-329.995 MHz: 1.0 µV
- DV (at BER 1% 4.8 kbps)
  - 2 Meters 0.22 µV
  - 70 cm 0.22 µV
Selectivity:
- AM/FM Wide: > 50dB
- FM Narrow, DV: > 45dB
- FM Wide: > 300 kHz/-3dB < 700 kHz/-20dB
Spurious and image rejection ratio:
- 144 MHz: More than -60 dB
- 430 (440) MHz: More than -50 dB
- (Except half IF, 2nd image, 50 MHz band IF and WFM)
Audio output power (at 25°C): 200 mW typical at 10% distortion w/8 ohm load
AF output impedance: 8 ohms